E1976A Datasheet, PDF (20/37 Pages) Keysight Technologies – E1966A 1xEV-DO Terminal Test Application

20 | Keysight | E1966A 1xEV-DO Terminal Test Application - Technical Overview
Option 103 – Multi-carrier Call Processing Functionality
(Requires E5515E or E5515C with serial prefix equal to or higher than GB4604xxxx or equivalent hardware and a
license for Option 102 1xEV-DO Release A and B feature option and Option 406 Multi-Unit Sync feature option)
Protocol stack
1xEV-DO Release B, Release A, or Release 0 (multi-carrier only in B)
Supported applications
Forward multi-carrier test application protocol in physical layer
subtype 3 (FMCTAP)
Reverse multi-carrier test application enhanced test application
protocol in physical layer subtype 3 (RMCTAP)
Multi-carrier test set configuration Main, auxiliary, and single (default single)
Number of supported carriers
Supports 1, 2, or three carriers using 1, 2, or 3 E5515C/E test sets
inter-connected via LAN. One unit is designated the multi-carrier master
while 1 or 2 other test sets are designated as auxiliary carrier units. The
main unit controls the call processing for all connected units.
Multi-carrier setup parameters
Auto setup external 8960 Series 10 1 state, external 8960 Series 10 IP
address, auto setup external 8960 Series 10 2 state, and external 8960
Series 10 2 IP Address
Automatic multicarrier setup
Execute command on the main unit that performs the external device
connection to all connected test sets and the required synchronization
for all connected test set
Multi-unit connection status
Displays testset configuration, local carrier state, connected carriers,
external device 1 status (connected with IP address or not connected) and
external device 2 status (connected with IP address or not connected)
Physical layer subtype
Subtype 3
Supported subtype 3 protocols
Default access channel MAC protocol or enhanced access channel MAC
protocol, enhanced forward traffic channel MAC protocol, subtype 3 reverse
traffic channel MAC protocol, and default control channel MAC protocol
Call control (from main unit only)
Access network open connection
Access network close connection
Access network close session
Access terminal open connection
Access terminal close connection
Hard handoff to new band and/or channel
Protocol status
Idle, Idle + Idle (Aux unit) UATI request, session negotiation, session
open, session closing, paging, connect request, connection negotiation,
connected, connected + connected (Aux unit), connection closing, handoff
Multi-carrier attributes in use
Max number forward links supported, max number reverse links
supported, max sub-active sets, max forward link bandwidth no jammer,
max forward link bandwidth jammer, max reverse link bandwidth, forward
feedback multiplexing, max optional data rate, and max optional payload size
Parameters independently
set on main
All main unit settings, and for both Aux 1 test set and Aux 2 test set the
following parameters: carrier state, channel, forward traffic DRC, F-traffic
packet length, R-data packet size, DRC value fixed mode, ACK channel
bit fixed mode, ACK channel modulation, ACK channel gain, DRC channel
gain, DRC length and channel drop rank
Parameters set on main only
Parameters set on each
individual test set
Cell band, all cell parameters, all access parameters, all enhanced
access parameters, all channel gain parameters, closed Loop power
control parameters
Cell power, physical layer subtype, all generator parameters, call drop
timer, Tx timing advance, max AT power, and all measurement parameters