E1976A Datasheet, PDF (15/37 Pages) Keysight Technologies – E1966A 1xEV-DO Terminal Test Application

15 | Keysight | E1966A 1xEV-DO Terminal Test Application - Technical Overview
Option 102 – Release A and B Call Processing Functionality
(Continued)
(Requires serial prefix equal to or higher than GB4604xxxx or equivalent hardware)
Base station parameters
PL subtype 0
PL subtype 2
PL subtype 3
PL2 traffic channel gain
parameters
Access channel subtype
(release A/B)
Access parameters
Enhanced access parameters
System parameters
Reverse data
transmission mode
Forward control channel
data rate
Session terminal displayed
parameters
Hardware ID types supported
Activity factor
AT directed packets
Limited TAP mode
Data offset nom, data offset 9k6, data offset 19k2, data offset 38k4, data
offset 76k8, data offset 153k6, ACK channel gain, and DRC channel gain
ACK channel gain, DRC channel gain, auxiliary pilot channel gain,
RRI channel gain pre-transition 0, RRI channel gain post-transition 0,
RRI channel gain pre-transition 1, RRI channel gain post-transition 1,
RRI channel gain pre-transition 2, RRI channel gain post-transition 2,
RRI channel gain pre-transition 3, auxiliary pilot channel min payload,
DSC length, short packets enabled threshold
All base station parameters used by PL subtype 0 and PL subtype2 are
validated for PL subtype 3 multicarriers (main carrier, auxiliary carrier 1
and auxiliary carrier 2)
For each of the 12 reverse channel payload packet sizes, the following
parameters are available (96 total): low latency T2P transition, low
latency termination target, low latency TxT2P pre-transition, low latency
TxT2P post-transition, high capacity TxT2P pre-transition, and high
capacity TxT2P post-transition
Enhanced (subtype 1 and subtype 3) or default (subtype 0).
Default of enhanced
Open loop adjust, probe initial adjust, probe power step, probe num
step, probe sequence max, and preamble length
Open loop adjust, probe initial adjust, probe power step, probe num
step, and probe sequence max. Preamble length fixed to 16 slots
Sector ID, country code, color code, subnet mask, and preferred control
channel cycle
High capacity or low latency. Default of high capacity
Selectable between 38.4 or 78.6 kbps
Session seed, hardware ID, assigned UATI, and assigned MAC index
ESN, MEID, “NNNN”
100% only
User-adjustable percentage (0 up to 100%) of forward traffic packets
directed to the AT under test. Default value of 50% per AT minimum
performance specification. Packets not direct to the AT under test are
sent to another MAC address that is not in use
On or Off with default of Off. This field is required to be set to On if the
AT uses firmware revisions that do not support the full test application
protocol as required by standard