E1976A Datasheet, PDF (19/37 Pages) Keysight Technologies – E1966A 1xEV-DO Terminal Test Application

19 | Keysight | E1966A 1xEV-DO Terminal Test Application - Technical Overview
Option 102 – Release A and B Call Processing Functionality
(Continued)
(Requires serial prefix equal to or higher than GB4604xxxx or equivalent hardware)
FETAP parameter assignment message
DRC value fixed mode
DRC cover fixed mode
Ack channel bit fixed mode
Loopback mode
Ack channel modulation type fixed mode
RETAP parameter assignment message
RETAP test packets enabled
Packet rate mode
Packet payload size mode
Enhanced access channel rate mode
Enhanced test application Enhanced test application
protocol = FETAP
protocol = RETAP
If DRCValueFixedMode attribute is On, attribute sent:
–– F-traffic format
If DRCValueFixedMode attribute is Off, attribute not sent
Attribute not sent
If Ack channel bit fixed mode attribute is On,
–– Attribute sent: ACK channel bit (fixed setting)
If Ack channel bit fixed mode attribute is Off, attribute not sent
Attribute sent: Enable
Attribute not sent
Ack channel bit fixed mode attribute is On:
–– Attribute sent: ACK channel modulation
(reverse ACK subtype 2)
Otherwise: Attribute not sent
Attribute sent: Enable (0x01)
Attribute not sent
Attribute not sent
Attribute sent:
–– min = R-data packet size
–– max = R-data packet size
Attribute sent: Enhanced access rate
Burst period mode
Burst size mode
Attribute not sent
Attribute sent:
–– LinkFlowID based on
R-data transmission mode
–– Period = Burst period
Attribute sent:
–– LinkFlowID based on
R-data transmission
mode
–– Size = Burst size