D55-B24-3058GDA Datasheet, PDF (31/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
BBAI NO.: 1293 1.0/2.3 Solder crimp Right Angle Jack
Tools Required:
Locator:
Assembly Instructions
Crimp Tool: see instruction 5
jacket
C
D
E
dielectrics
(*) 1 max
(.039)
braids
center
conductor
(*) Trim the intermediate foil to the
indicated dimension
1. Trim cable to the dimensions shown, being careful not to damage the braid, dielectric, foil
or inner conductor.
Stripping Detail
A
B
+0.00 (+.000)
C -0.50 (- .019)
+0.20 (+.008)
D -0.00 (- .000)
+0.00 (+.000)
E -0.20 (- .008)
11.00 (.433)
5.00 (.197)
3.00 (.118)
12.50 (.492)
5.00 (.197)
3.00 (.118)
For cables with a foil under the braid, spread braid and trim back to dimensions shown.
The foil should be left in place over the dielectric.
2. If fitted, remove the cap from the body of the connector.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help) and ensure that the conductor fits into the slot in the rear
of the contact.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
BT 3002
ST214
ST 212
RG 179 B/U
Stripping
Detail
A
A
A
A
Die
Size
4.30 (.170)
3.25 (.128)
3.80 (.151)
3.25 (.128)
Die Part
Number
K29265
K29263
T1025/9
K29263
Dimensions are shown in mm (inch)
Dimensions subject to change ₃₁
www.ittcannon.com