D55-B24-3058GDA Datasheet, PDF (25/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
BBAI NO.: 1276 Type 54 Solder- crimp right angle plug
Tools Required:
Locator: -
Assembly Instructions
Sheet 1 of 2
Crimp Tool: see instruction 5
1. Trim cable to the dimensions shown, being careful not to damage the braid,
dielectric, foil or inner conductor.
(*) 1 max
(*) Trim the intermediate foil to
the indicated dimension
Stripping Detail
A
+0.00 (+.000)
C -0.50 (- .019)
+0.20 (+.008)
D -0.00 (- .000)
+0.00 (+.000)
E -0.20 (- .008)
6.00 (.236)
7.00 (.276)
3.00 (.118)
For cables with a foil under the braid, spread braid and trim back to dimensions
shown. The foil should be left in place over the dielectric, except for RA 7000 and
5000 cable, where the foil should be left in place over the dielectric.
2. If fitted, remove the cap from the body of the connector.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help) and ensure that the conductor fits into the slot in the rear
of the contact.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
BT 3002
BT 2003
BT 5000
RA 7000
Stripping
Detail
A
A
A
A
Die
Size
4.52 (.178)
6.81 (.268)
8.23 (.324)
5.18 (.204)
Die Part
Number
T1025/5
T1025/8
T1025/17
T1025/6
6. Solder the conductor to the contact and press in the cap using Cannon tool T2921
equipped with the tool adaptor T4872 and with the bolt adaptor T4880 (see next
page).
Dimensions are shown in mm (inch)
Dimensions subject to change ₂₅
www.ittcannon.com