D55-B24-3058GDA Datasheet, PDF (30/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
Assembly Instructions
BBAI NO.: 1289 1.0/2.3 Full - crimp/Solder - crimp straight plugs 50 ohm
Tools Required:
Locator: T4852
Crimp Tool: see table
(*) Trim the intermediate foil to the
indicated dimension
1. Prepare cable to the dimensions shown, being careful not to damage the braid,
dielectric, foil or inner conductor.
Stripping Detail
+0.00 (+.000)
C -0.50 (- .019)
+0.00 (+.000)
D -0.30 (- .012)
+0.00 (+.000)
E -0.20 (- .008)
A
6.00 (.236)
8.30 (.327)
3.50 (.138)
For cables with a foil under the braid, spread braid and trim back to dimension
shown.
2. Crimp contact onto inner conductor using a M22520/2-01 (Cannon part number
995-0001-584) set to the selector number shown in the table below, fitted with
positioner T4852 .
Ensure that the conductor is visible through the inspection hole in the side of the
contact.
This contact may also be soldered.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help). Push home until a click is felt.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
RG 58/U
RG 316/U
Stripping
Detail
A
A
Selector
Setting
4
4
Die
Size
5.41 (.213)
3.25 ((.128)
Die Part
Number
K29265
K29263
Dimensions are shown in mm (inch)
30
Dimensions subject to change
www.ittcannon.com