D55-B24-3058GDA Datasheet, PDF (24/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
BBAI NO.: 1269 1.0/2.3 full - crimp/solder - crimp straight plugs
Tools Required:
Locator: T4852
Crimp Tool: see table
Assembly Instructions
E
dielectric
center
conductor
D
C
jacket
(*) 1 max
(.039)
(*) Trim the intermediate foil to the
indicated dimension
crimping
24
1. Prepare cable to the dimensions shown, being careful not to damage the braid,
dielectric, foil or inner conductor.
Stripping Detail
+0.00 (+.000)
C -0.50 (- .019)
+0.00 (+.000)
D -0.30 (- .012)
+0.00 (+.000)
E -0.20 (- .008)
A
6.00 (.236)
8.30 (.327)
3.50 (.138)
B
8.00 (.315)
10.50 (.413)
3.50 (.138)
For cables with a foil under the braid, spread braid and trim back to dimension
shown. Except RA 7000 cable where the foil should be left in place over the dielectric.
2. Crimp contact onto inner conductor using a M22520/2-01 (Cannon part number
995-0001-584) set to the selector number shown in the table below, fitted with
positioner T4852.
Ensure that the conductor is visible through the inspection hole in the side of the
contact.
This contact may also be soldered.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help). Push home until a click is felt.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
A (0.4/2.4)
B (0.25/1.45)
BT2003
BT3002
FLEX 2
RG179B/U
ST212
ST214
TZC75005
RA7000
RD179
Stripping
Detail
B
A
B
A
A
A
A
B
B
B
A
Selector
Setting
3
3
4
3
3
3
3
4
4
4
3
Die
Size
5.4 (.213)
3.25 (.128)
6.8 (.268)
4.3 (.170)
3.25 (.128)
3.25 (.128)
3.8 (.151)
6.8 (.268)
6.5 (.255)
5.18 (.204)
3.84 (.151)
Die Part
Number
K29265
K29263
T1025/8
T1025/36
K29263
K29263
T1025/9
T1025/8
T1025/11
T1025/6
T1025/9
Dimensions are shown in mm (inch)
Dimensions subject to change
www.ittcannon.com