D55-B24-3058GDA Datasheet, PDF (28/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
BBAI NO.: 1280 Full - crimp/Solder - crimp straight plugs
Tools Required:
Locator: -
Assembly Instructions
Crimp Tool: see table
(*) 1 max
1. Prepare cable to the dimensions shown, being careful not to damage the braid,
dielectric, foil or inner conductor.
Stripping Detail
A
B
+0.00 (+.000)
C -0.50 (- .019)
+0.20 (+.008)
D -0.00 (- .000)
+0.00 (+.000)
E -0.20 (- .008)
6.00 (.236)
8.30 (.327)
3.50 (.138)
8.00 (.315)
10.50 (.413)
3.50 (.138)
For cables with a foil under the braid, spread braid and trim back to dimensions
shown.
2. Crimp contact onto inner conductor using a T4870 (Cannon part number , square
dimension shown in the table below).
Ensure that the conductor is visible through the inspection hole in the side of the
contact.
This contact may also be soldered.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help). Push home until a click is felt.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
ST212
ST214
Stripping
Detail
A
B
Square
Dimension (mm)
0.7 x 0.7
1.0 x 1.0
Die
Size
3.8 (.151)
6.8 (.268)
Die
Part Number
T1025/9
T1025/8
Dimensions are shown in mm (inch)
28
Dimensions subject to change
www.ittcannon.com