D55-B24-3058GDA Datasheet, PDF (23/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
BBAI NO.: 1265 Type 43 (SMZ) single body and Type 54 straight
Tools Required:
Locator: T4841 and T4881 (5000 cable only)
Crimp Tool: T4519
Assembly Instructions
Connectors - Type 43 (SMZ)
or Type 54 Push-Pull
Contacts
Ferrule
Locator
T4841 - White
T4881 - Orange
5000 cable only
(*) 1mm max
(*) Trim the intermediate foil to the
indicated dimension
1. Strip the cable to the dimensions shown taking care not to
damage the braid, dielectric or inner conductor.
NOTE:
For RA7000 and 5000 cable, leave the foil in place over the
dielectric.
2. Insert the cable centre conductor into the back of the contact.
Ensure the dielectric butts against the contact.
Insert the cable/contact into the locator and load to the crimp tool
(T4519).
Crimp the contact to the cable. Ensure that the cable is visible
through the Contact Inspection Hole.
3. Slide the ferrule over the cable. Insert the cable/contact assembly
into the tubular extension of the body, gently twisting and rocking
the connector body to spread the braid will help.
The contact will snap into position in the connector. Slide the ferrule
over the braid and crimp using tool no. T1025/- fitted with the
appropriate die set (see table below).
cable across flats dim.
2001
4.52 mm
2002
5.18 mm
2003
6.81 mm
RD179B/U 3.84 mm
5000
8.23 mm
die set no.
T1025/5
T1025/6
T1025/8
T1025/9
T1025/17
cable ^{across flats dim.}
RG179B/U ^{3.25 mm}
TZC75024 ^{4.52 mm}
3002
4.52 mm
RA7000 ^{5.18 mm}
die set no.
K29263
T1025/5
T1025/5
T1025/6
Dimensions are shown in mm (inch)
Dimensions subject to change ₂₃
www.ittcannon.com