D55-B24-3058GDA Datasheet, PDF (29/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
Assembly Instructions
BBAI NO.: 1281 1.0/2.3 Straight jack full - crimp 50 ohm and 75 ohm
Tools Required:
Locator: T4852
Crimp Tool: see table
1. Prepare cable to the dimensions shown, being careful not to damage the braid,
dielectric, foil or inner conductor.
Stripping Detail
+0.00 (+.000)
C -0.50 (- .019)
+0.00 (+.000)
D -0.30 (- .012)
+0.00 (+.000)
E ^{-0.20 (- .008)}
A
6.00 (.236)
9.50 (.374)
3.50 (.138)
B
8.00 (.315)
11.7 (.460)
3.50 (.138)
For cables with a foil under the braid, spread braid and trim back to dimension
shown. The foil should be left in place over the dielectric, except RA 7000 cable
where the foil should be left in place over the dielectric.
2. Crimp contact onto inner conductor using a M22520/2-01 (Cannon part number
995-0001-584) set to the selector number shown in the table below, fitted with
positioner T4852.
Ensure that the conductor is visible through the inspection hole in the side of the
contact.
This contact may also be soldered.
3. Place the crimp ferrule over the cable sheath.
4. Fit the connector body onto the cable/conductor so that the rear body slides
between the dielectric and braid (gently twisting and rocking the connector body to
spread the braids will help). Push home until a click is felt.
5. Slide the crimp ferrule forward, over the braid until it butts against the rear of the
connector. Crimp using Cannon crimp tool T1025/- fitted with a suitable die set (see
table ).
Cable
Type
RG 58
RG 316
ST 212
ST 214
BT 2003
BT 3002
RA 7000
TZC 75005
A (04/2.4)
B (0.25/1.45)
RG179
FLEX 2
Stripping
Detail
A
A
A
B
B
A
B
B
B
A
A
A
Selector
Setting
4
4
3
4
4
3
4
4
3
3
3
3
Die
Size
5.41 (.213)
3.25 (.128)
3.80 (.151)
6.80 (.268)
6.80 (.268)
4.30 (.170)
5.18 (.204)
6.50 (.255)
5.40 (.213)
3.25 (.128)
3.25 (.128)
3.25 (.128)
Die Part
Number
K29265
K29263
T1025/9
T1025/8
T1025/8
T1025/36
T1025/6
T1025/11
K29265
K29263
K29263
K29263
Dimensions are shown in mm (inch)
Dimensions subject to change ₂₉
www.ittcannon.com