D55-B24-3058GDA Datasheet, PDF (2/35 Pages) ITT Industries – 1.0/2.3 RF Connector Series

RF Coaxial Connectors
Description
Introduction
1.0/2.3 50 Ohm Range
1.0/2.3 75 Ohm Plugs
Type 54 Range
1.0/2.3 75 Ohm Jacks
MID - Surface Mount Jacks
Baluns
U - Links
1.0/2.3 - 1.0/2.3 In - Series Adaptors
1.0/2.3 - 1.6/5.6 Between - Series Adaptors
1.0/2.3 - BNC Between - Series Adaptors
Terminations & Attenuators
Tooling
Assembly Instructions
Part Number Index
Other ITT Cannon Product Listing
Product Safety Information
Contents
Page
3
5
7
8
9
12
16
17
18
19
20
21
22
23
32
33
34
RF0104
2
ITT Cannon, a Division of ITT Industries, Inc. manufactures the highest quality products available in the marketplace; however these products are
intended to be used in accordance with the specifications in this publication. Any use or application that deviates from the stated operating specifications
is not recommended and may be unsafe. No information and data contained in this publication shall be construed to create any liability on the part
of Cannon.
Any new issue of this publication shall automatically invalidate and supersede any and all previous issues. A limited warranty applies to Cannon
products. Except for obligations assumed by Cannon under this warranty, ITT Industries shall not be liable for any loss, damage, cost of
repairs, incidental or consequential damages of any kind, whether or not based on express or implied warranty, contract, negligence, or strict
liability arising in connection with the design, manufacture, sale, use, or repair of the products. Product availability, prices and delivery dates
are exclusively subject to our respective order confirmation form; the same applies to orders based on development samples delivered. This publication
is not to be construed as an offer. It is intended merely as an invitation to make an offer. By this publication, Cannon does not assume responsibility
or any liability for any patent infringements or other rights of third parties which may result from its use. Reprinting this publication is generally permitted,
indicating the source. However, Cannon‘s prior consent must be obtained in all cases.
Cannon is a trademark of ITT Industries, Inc.
Dimensions are shown in mm (inch)
Dimensions subject to change
www.ittcannon.com