English
Language : 

TLE8110EE Datasheet, PDF (62/72 Pages) Infineon Technologies AG – Smart Multichannel Low Side Switch with Parallel Control and SPI Interface
Field
Bits
DCC_
11:8
DMS1
DCC_
11:8
DMS2
DCC_
11:8
DMS3
DCC_
7:0
DMSx/OPSx
Type
W
W
W
W
FLEX
Smart Multi-Channel Switch
Control of the device
Description
DMS1/OPSx - Diagnosis Mode Set, Register1 / Output Pins Set
On sending this command, the diagnosis registers DR1 is selected.
Output Pin Settings are done according the content of OPSx.
Returns the contents of DR1 on SO in the 2nd byte of the actual
communication frame and the Output Pin Feedback in the 1st
Byte of the next frame. (see Chapter 12.3.2.3)
DMS2/OPSx - Diagnosis Mode Set, Register2 / Output Pins Set
On sending this command, the diagnosis registers DR2 is selected.
Output Pin Settings are done according the content of OPSx.
Returns the contents of DR2 on SO in the 2nd byte of the actual
communication frame and the Output Pin Feedback in the 1st
Byte of the next frame. (see Chapter 12.3.2.3)
DMS3/OPSx - Diagnosis Mode Set, Register3 / Output Pins Set
On sending this command, the diagnosis registers DR3 is selected.
Output Pin Settings are done according the content of OPSx.
Returns the contents of DR3 on SO in the 2nd byte of the actual
communication frame and the Output Pin Feedback in the 1st
Byte of the next frame. (see Chapter 12.3.2.3)
DMSx/OPS1 - Diagnosis Mode Set x/ Output Pin Set Command 1
On sending this command, the diagnosis register is selected
according DMSx. The Output Pins of Channel 7-10 are set
according the following definitions. The OPSx are commands,
no register. The commands are controlling the contents of ISA,
ISB and OUTx.
OPS[7:0] - Output Pin Set
0000 0001: CH7 input select, 1: parallel* / 0 : Serial
0000 0010: CH8 input select, 1: parallel* / 0 : Serial
0000 0100: CH9 input select, 1: parallel* / 0 : Serial
0000 1000: CH10 input select, 1: parallel* / 0 : Serial
0001 0000: CH7 output set, 1: ON / 0:OFF
0010 0000: CH8 output set, 1: ON / 0:OFF
0100 0000: CH9 output set, 1: ON / 0:OFF
1000 0000: CH10 output set, 1: ON / 0:OFF
(*parallel controlled by INx)
Sending OR operated combinations of above listed options (only
OPSx) are possible in order to control more then one channel at
the same time.
If parallel mode Mode is selected (in “input select”), the serial settings
(in “output select”) are ignored.
In parallel Mode, the selected Channels are controlled via INx Pins.
The default setting of ISB corresponds the command OPS[7:0] = xxxx
1111b. (parallel mode, status of the Outputs according signal on
INx)
Returns the contents the selected DRx register on SO in the 2nd byte
of the actual communication frame and the Output Pin
Feedback [OPF] in the 1st Byte of the next frame. (see
Chapter 12.3.2.3)
Data Sheet
62
Rev. 1.0, 2009-06-15