XC164CS-16F Datasheet, PDF (57/78 Pages) Infineon Technologies AG – 16-Bit Single-Chip Microcontroller with C166SV2 Core

XC164-16
Derivatives
Electrical Parameters
Table 11 DC Characteristics (Operating Conditions apply)¹⁾ (cont’d)
Parameter
Symbol
Limit Values
Unit Test Condition
Level inactive hold
current¹²⁾
Level active hold
current¹²⁾
I_LHI9)
I_LHA10)
Min.
–
-100
Max.
-10
–
µA V_OUT = 0.5 ×
V_DDP
µA V_OUT = 0.45 V
XTAL1 input current I_IL
Pin capacitance¹³⁾
C_IO
(digital inputs/outputs)
CC –
CC –
±20
µA 0 V < V_IN < V_DDI
10
pF –
1) Keeping signal levels within the limits specified in this table, ensures operation without overload conditions.
For signal levels outside these specifications, also refer to the specification of the overload current I_OV.
2) This parameter is tested for P3, P4, P9.
3) The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table 12, Current Limits for Port Output Drivers. The limit for pin groups must be respected.
4) As a rule, with decreasing output current the output levels approach the respective supply level (V_OL → V_SS,
V_OH → V_DDP). However, only the levels for nominal output currents are guaranteed.
5) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
6) An additional error current (I_INJ) will flow if an overload current flows through an adjacent pin. Please refer to
the definition of the overload coupling factor K_OV.
7) The driver of P3.15 is designed for faster switching, because this pin can deliver the reference clock for the
bus interface (CLKOUT). The maximum leakage current for P3.15 is, therefore, increased to 1 µA.
8) This specification is valid during Reset for configuration on RD, WR, EA, PORT0
9) The maximum current may be drawn while the respective signal line remains inactive.
10) The minimum current must be drawn to drive the respective signal line active.
11) This specification is valid during Reset for configuration on ALE.
12) This specification is valid during Reset for pins P4.3-0, which can act as CS outputs, and for P3.12.
13) Not subject to production test - verified by design/characterization.
Table 12 Current Limits for Port Output Drivers
Port Output Driver
Mode
Strong driver
Maximum Output Current
(I_OLmax, -I_OHmax)¹⁾
10 mA
Nominal Output Current
(I_OLnom, -I_OHnom)
2.5 mA
Medium driver
4.0 mA
1.0 mA
Weak driver
0.5 mA
0.1 mA
1) An output current above |I_OXnom| may be drawn from up to three pins at the same time.
For any group of 16 neighboring port output pins the total output current in each direction (ΣI_OL and Σ-I_OH) must
remain below 50 mA.
Data Sheet
55
V2.2, 2006-03