TC1736 Datasheet, PDF (108/123 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1736
Electrical Parameters
With rising number m of clock cycles the maximum jitter increases linearly up to a value
of m that is defined by the K2-factor of the PLL. Beyond this value of m the maximum
accumulated jitter remains at a constant value. Further, a lower LMB-Bus clock
frequency f_LMB results in a higher absolute maximum jitter value.
Figure 18-10 gives the jitter curves for several K2 / f_LMB combinations.
±10.0
D_{m ns}
±8.0
f_LMB = 40 MHz (K2 = 10)
f_LMB = 40 MHz (K2 = 20)
±7.0
±6.0
±4.0
f_LMB = 80 MHz (K2 = 6)
±2.0
f_LMB = 80 MHz (K2 = 10)
±1.0
±0.0
0
20
40
60
80
100
D_m = Max. jitter
m = Number of consecutive f_LMB periods
K2 = K2-divider of PLL
120
oo
m
TC1736_PLL_JITT
Figure 10
Approximated Maximum Accumulated PLL Jitter for Typical LMB-
Bus Clock Frequencies f_LMB
Note: The specified PLL jitter values are valid if the capacitive load per output pin does
not exceed C_L = 20 pF with the maximum driver and sharp edge. In case of
applications with many pins with high loads, driver strengths and toggle rates the
specified jitter values could be exceeded.
Note: The maximum peak-to-peak noise on the pad supply voltage, measured between
V_DDOSC3 at pin 85 and V_SSOSC at pin 83, is limited to a peak-to-peak voltage of
V_PP = 100 mV for noise frequencies below 300 KHz and V_PP = 40 mV for noise
frequencies above 300 KHz.
The maximum peak-to peak noise on the pad supply votage, measured between
V_DDOSC at pin 84 and V_SSOSC at pin 83, is limited to a peak-to-peak voltage of
V_PP = 100 mV for noise frequencies below 300 KHz and V_PP = 40 mV for noise
frequencies above 300 KHz.
Data Sheet
104
V1.1, 2009-08