S9407-AB-HBK-010 Datasheet, PDF (77/276 Pages) Glenair, Inc. – HANDBOOK OF SHIPBOARD ELECTROMAGNETIC SHIELDING PRACTICES

S9407-AB-HBK-010, Rev. 2
The term "reusable" means that an end fitting or coupling can be readily attached to or
removed from conduit simply by tightening or loosening a gripping mechanism.
Table 5-1 lists the RP2000-Series fittings. These fittings are illustrated in the data sheets (see
paragraph 5.12).
Type
End Fittings
Couplings
Adapters
(Connectors)
Adapters
(Misc)
Adapter (End)
Adapters
(Angle)
Fig.
No.
5-1
5-2
5-3
5-4
5-5
5-6
5-7
5-8
5-9
5-10
5-11
5-12
5-13
5-14
5-15
5-16
5-17
5-18
5-19
5-20
5-21
5-22
5-23
Table 5-1. RP2000-Series Fittings
Basic
Part No.
RP2100
RP2110
RP2120
RP2130
RP2140
RP2141
RP2200
RP2210
RP2311
RP2321
RP2330
RP2340
RP2350
RP2360
RP2400
RP2411
RP2420
RP2430
RP2431
RP2440
RP2500
RP2610
RP2620
Description
Conduit End Fitting, Straight
Conduit End Fitting, 90°
Conduit End Fitting, 45°
End Fitting, Conduit-to-Panel
End Fitting, Conduit-to-Pipe Thd (Tapered)
End Fitting, Conduit-to-Pipe Thd (Straight)
Coupling, Conduit-to-Conduit
Coupling, Conduit-to-Pipe
Adapter for MIL-C-5015 Connector
Adapter for Triaxial Connector
Adapter for Coaxial Connector
Adapter for MIL-C-26482 Connector
Adapter for MS3155 Type Connectors
Adapter for MIL-C-28840(EC) Backshell
Adapter for MIL-S-24235/1 Stuffing Tube
Adapter for Misc Threaded Fittings
Adapter for MIL-C-24231 Hull Fitting
Adapter for Pipe Thread (Tapered)
Adapter for Pipe Thread (Straight)
Adapter, Nonmetallic
Adapter for Panel Termination
Adapter, 90°
Adapter, 45°
5.4.2 Basic Construction
The illustrations in the data sheets, figures 5-1 through 5-23, show the basic construction and
the essential characteristics of the RP2000-Series fittings. The illustrations are those of typical fittings
and are intended to show function only. Other constructional details are left to the option of the
manufacturer except as noted elsewhere in this specification. Welded fabrication of the fittings is
allowed. Dimensions and thread sizes shown are those which must exist after plating is completed.
5-3