S9407-AB-HBK-010 Datasheet, PDF (221/276 Pages) Glenair, Inc. – HANDBOOK OF SHIPBOARD ELECTROMAGNETIC SHIELDING PRACTICES

S9407-AB-HBK-010, Rev. 2
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract, the supplier is
responsible for the performance of all inspection requirements as specified herein. except as
otherwise specified in the contract, the supplier may use his own or any other facility suitable for the
performance of the inspection requirements specified herein, unless disapproved by the Government.
The Government reserves the right to perform any of the inspections set forth in this specification
where such inspections are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.1.1 Test equipment and inspection facilities. Test and measuring equipment and inspection
facilities of sufficient accuracy, quality, and quantity to permit performance of the required inspection
shall be established and maintained by the supplier and/or a government approved subcontract
facility.
4.2 Classification of inspections. The inspections for the conduit are classified herein as follows:
Inspection
Paragraph
Materials inspection ...................................................................................... 4.3
Qualification inspection ................................................................................. 4.4
Quality conformance inspection.................................................................... 4.5
4.3 Materials inspection. Materials inspection shall consist of certification that the materials and
annealing process listed in table II were used in fabricating the delivered flexible conduit.
4.4 Qualification inspection. Qualification inspection for inclusion in a qualified products list (QPL)
(see 6.3) shall be performed by the Government on test samples that were produced with equipment
and procedures normally used in production. The qualification test samples (see 4.4.1) shall be
subjected to the inspections specified in table III.
Table II. Materials inspection.
Material or process
Tubing
Coupling ring
Requirement
Paragraph
Applicable specification
3.5.1
ANSI/ASTM-A-753, Alloy Type 4
3.5.1
ANSI/ASTM-A-753, Alloy Type 4
Annealing
Seam interlock material
Braid
Jacket
Heatshrinkable tubing
3.5.2
3.5.3
3.5.4
3.5.5
3.5.6
In accordance with standard practice
QQ-B-650, Class BCu-1
QQ-S-763, Class 304 or 321
MIL-R-6855, Class 2A, Grade 60
MIL-I-230053/1, Class 1, or
MIL-R-46846, Type 1, Class 1
Reprinted without change
D-7