S9407-AB-HBK-010 Datasheet, PDF (229/276 Pages) Glenair, Inc. – HANDBOOK OF SHIPBOARD ELECTROMAGNETIC SHIELDING PRACTICES

S9407-AB-HBK-010, Rev. 2
6.2 Ordering data. Procurement documents should specify the following:
a. Name of item: “Shielding conduit, per S9407-AB-HBK-010.”
b. Type of conduit to be furnished (see 1.2.1).
c. Conduit size (nominal ID, see table I).
d. Conduit part number.
e. Length (s), and tolerances, if required.
f. Type of splice in rubber jacket (specify, if necessary, either overlap or butt joint, see
3.6.7).
g. Special marking, if required.
h. Certified test reports, if required (see 4.7).
i. DCAS inspection, if required (see 4.8).
6.3 Qualified products list. A qualified products list for flexible conduit for low frequency shielding is
maintained for Navy procurement purposes. It provides information concerning flexible conduit which
meets the requirements specified herein. Manufacturers wishing to have their product tested for
qualification should send samples as set forth in 4.4.1, together with manufacturer’s technical data as
specified in 3.10, to Naval Undersea Warfare Center, Code 3431, Newport, RI 02841-1708. No
indebtedness between the U.S. Government and any manufacturer will be incurred in connection with
the qualification testing described herein. Samples sent for testing shall be sent prepaid by the
manufacturer and will not be returned.
6.3.1 Qualification provisions. Conduit which is tested shall meet the requirements of this
specification in order to be approved by Naval Sea Systems Command and added to the qualified
products list. Listing of a product does not release the supplier from compliance with the specification
requirements and connote endorsement of the product by the Navy. Information concerning this
listing is available from the Naval Sea Systems Command, Code 05K2B, Arlington, VA 22242,
telephone [phone].
CHANGE 1 of Revision 2
D-15