MB85RS2MTPF-G Datasheet, PDF (9/28 Pages) Fujitsu Component Limited. – 2 M (256 K × 8) Bit SPI

MB85RS2MT
• READ
The READ command reads FRAM memory cell array data. Arbitrary 24 bits address and op-code of READ
are input to SI. The 6-bit upper address bit is invalid. Then, 8-cycle clock is input to SCK. SO is output
synchronously to the falling edge of SCK. While reading, the SI value is invalid. When CS is risen, the READ
command is completed, but keeps on reading with automatic address increment which is enabled by con-
tinuously sending clocks to SCK in unit of 8 cycles before CS rising. When it reaches the most significant
address, it rolls over to the starting address, and reading cycle keeps on infinitely. READ command is
applicable to “Up to 25 MHz operation”.
CS
SCK
SI
SO
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 26 27 28 29 30 31 32 33 34 35 36 37 38 39
OP-CODE
24-bit Address
0 0 0 0 0 0 1 1 X X X X X X 17 16
543210
Invalid
MSB
High-Z
LSB MSB
Data Out _LSB
76543210
Invalid
• WRITE
The WRITE command writes data to FRAM memory cell array. WRITE op-code, arbitrary 24 bits of address
and 8 bits of writing data are input to SI. The 6-bit upper address bit is invalid. When 8 bits of writing data is
input, data is written to FRAM memory cell array. Risen CS will terminate the WRITE command, but if you
continue sending the writing data for 8 bits each before CS rising, it is possible to continue writing with
automatic address increment. When it reaches the most significant address, it rolls over to the starting
address, and writing cycle can be continued infinitely. WRITE command is applicable to “Up to 25 MHz
operation”.
CS
SCK
SI
SO
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
26 27 28 29 30 31 32 33 34 35 36 37 38 39
OP-CODE
24-bit Address
Data In
0 0 0 0 0 0 1 0 X X X X X X 17 16
54321076543210
MSB
High-Z
LSB MSB
LSB
DS501-00023-0v01-E
9