MC9S08SG32 Datasheet, PDF (301/328 Pages) Freescale Semiconductor, Inc – HCS08 Microcontrollers

#C
Appendix A Electrical Characteristics
Table A-7. Supply Current Characteristics (continued)
Parameter
Symbol
V_DD
(V)
Typ¹
Max²
Unit
Temp Rated
Stop2 mode supply current
C
–40°C (C,M, and V suffix)
0.94
–
μA
♦
—
P
25°C (All parts)
1.25
–
μA
♦
—
P⁵
85°C (C suffix only)
5
13.4
30
μA
♦
—
P⁵
105°C (V suffix only)
30
65
μA
♦
—
5 _P⁵
C
125°C (M suffix only)
–40°C (C,M, and V suffix)
S2I_DD
65
120 μA
♦
—
0.83
–
μA
♦
—
P
25°C (All parts)
1.1
–
μA
♦
—
P⁵
85°C (C suffix only)
3
11.5
25
μA
♦
—
P⁵
105°C (V suffix only)
25
55
μA
♦
—
P⁵
125°C (M suffix only)
57
100 μA
♦
—
RTC adder to stop2 or stop3⁶
6C
S23I
5
300
500
nA
♦
—
DDR
TI
3
300
500
nA
♦
—
LVD adder to stop3 (LVDE = LVDSE = 1)
5
110
180
μA
♦
—
7C
S3I_DDLVD
3
90
160 μA
♦
—
8
C
Adder to stop3 for oscillator enabled⁷
(EREFSTEN =1)
S3I
DDOS
5,3
5
8
μA
♦
—
C
1 _{Typical values are based on characterization data at 25°C. See Figure A-5 through Figure A-7 for typical curves across}
temperature and voltage.
2 _{Max values in this column apply for the full operating temperature range of the device unless otherwise noted.}
3 _{All modules except ADC active, ICS configured for FBELP, and does not include any dc loads on port pins}
4 _{All modules except ADC active, ICS configured for FEI, and does not include any dc loads on port pins}
5 _{Stop Currents are tested in production for 25 Con all parts. Tests at other temperatures depend upon the part number suffix}
and maturity of the product. Freescale may eliminate a test insertion at a particular temperature from the production test flow
once sufficient data has been collected and is approved.
6 _{Most customers are expected to find that auto-wakeup from stop2 or stop3 can be used instead of the higher current wait}
mode.
7 _{Values given under the following conditions: low range operation (RANGE = 0) with a 32.768kHz crystal and low power mode}
(HGO = 0).
MC9S08SG32 Data Sheet, Rev. 7
Freescale Semiconductor
301