MC68HC908GZ60 Datasheet, PDF (291/352 Pages) Freescale Semiconductor, Inc – Microcontrollers

19.8.1 TIM2 Status and Control Register
The TIM2 status and control register:
• Enables TIM2 overflow interrupts
• Flags TIM2 overflows
• Stops the TIM2 counter
• Resets the TIM2 counter
• Prescales the TIM2 counter clock
I/O Registers
Address: $002B
Bit 7
6
5
4
3
2
1
Bit 0
Read: TOF
0
0
TOIE TSTOP
Write: 0
TRST
PS2
PS1
PS0
Reset: 0
0
1
0
0
0
0
0
= Unimplemented
Figure 19-5. TIM2 Status and Control Register (T2SC)
TOF — TIM2 Overflow Flag Bit
This read/write flag is set when the TIM2 counter resets reaches the modulo value programmed in the
TIM2 counter modulo registers. Clear TOF by reading the TIM2 status and control register when TOF
is set and then writing a 0 to TOF. If another TIM2 overflow occurs before the clearing sequence is
complete, then writing 0 to TOF has no effect. Therefore, a TOF interrupt request cannot be lost due
to inadvertent clearing of TOF. Reset clears the TOF bit. Writing a 1 to TOF has no effect.
1 = TIM2 counter has reached modulo value
0 = TIM2 counter has not reached modulo value
TOIE — TIM2 Overflow Interrupt Enable Bit
This read/write bit enables TIM2 overflow interrupts when the TOF bit becomes set. Reset clears the
TOIE bit.
1 = TIM2 overflow interrupts enabled
0 = TIM2 overflow interrupts disabled
TSTOP — TIM2 Stop Bit
This read/write bit stops the TIM2 counter. Counting resumes when TSTOP is cleared. Reset sets the
TSTOP bit, stopping the TIM2 counter until software clears the TSTOP bit.
1 = TIM2 counter stopped
0 = TIM2 counter active
NOTE
Do not set the TSTOP bit before entering wait mode if the TIM2 is required
to exit wait mode. Also when the TSTOP bit is set and the timer is
configured for input capture operation, input captures are inhibited until the
TSTOP bit is cleared.
TRST — TIM2 Reset Bit
Setting this write-only bit resets the TIM2 counter and the TIM2 prescaler. Setting TRST has no effect
on any other registers. Counting resumes from $0000. TRST is cleared automatically after the TIM2
counter is reset and always reads as 0. Reset clears the TRST bit.
1 = Prescaler and TIM2 counter cleared
0 = No effect
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
Freescale Semiconductor
291