English
Language : 

S9S12G128F0MLL Datasheet, PDF (170/1292 Pages) Freescale Semiconductor, Inc – Reference Manual and Date Sheet
Port Integration Module (S12GPIMV1)
• When routing of ADC channels to PC4-PC0 is selected
(PRR1[PRR1AN]=1) the related bit in the ADC Digital Input Enable
Register (ATDDIEN) must be set to 1 to activate the digital input
function on those pins not used as ADC inputs. If the external trigger
source is one of the ADC channels, the digital input buffer of this
channel is automatically enabled.
PC7
PC6
PC5
PC4-PC2
PC1-PC0
Table 2-8. Port C Pins PC7-0
• 100 LQFP: The unbuffered analog output signal DACU1 of the DAC1 module is mapped to this pin if
the DAC is operating in “unbuffered DAC” mode. If this pin is used with the DAC then the digital I/O
function and pull device are disabled.
• Signal priority:
100 LQFP: DACU1 > GPO
• 100 LQFP: The non-inverting analog input signal AMPP1 of the DAC1 module is mapped to this pin if
the DAC is operating in “unbuffered DAC with operational amplifier” or “operational amplifier only”
mode. If this pin is used with the DAC then the digital input buffer is disabled.
• Signal priority:
100 LQFP: GPO
• 100 LQFP: The inverting analog input signal AMPM1 of the DAC1 module is mapped to this pin if the
DAC is operating in “unbuffered DAC with operational amplifier” or “operational amplifier only” mode.
If this pin is used with the DAC then the digital input buffer is disabled.
• Signal priority:
100 LQFP: GPO
• 100 LQFP: If routing is active (PRR1[PRR1AN]=1) the ADC analog input channel signals AN15-13 and
their related digital trigger inputs are mapped to these pins. The routed ADC function has no effect on
the output state. Refer to NOTE/2-171 for input buffer control.
• Signal priority:
100 LQFP: GPO
• 100 LQFP: If routing is active (PRR1[PRR1AN]=1) the ADC analog input channel signals AN11-10 and
their related digital trigger inputs are mapped to these pins. The routed ADC function has no effect on
the output state. Refer to NOTE/2-171 for input buffer control.
• Signal priority:
100 LQFP: GPO
MC9S12G Family Reference Manual, Rev.1.23
172
Freescale Semiconductor