English
Language : 

MC35XS3400 Datasheet, PDF (10/45 Pages) Freescale Semiconductor, Inc – Quad High Side Switch (Quad 35mΩ)
ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
DYNAMIC ELECTRICAL CHARACTERISTICS
Table 4. Dynamic Electrical Characteristics
Characteristics noted under conditions 6.0V ≤ VPWR ≤ 20V, 3.0V ≤ VDD ≤ 5.5V, - 40°C ≤ TA ≤ 125°C, GND = 0V, unless
otherwise noted. Typical values noted reflect the approximate parameter means at TA = 25°C under nominal conditions, unless
otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
POWER OUTPUT TIMING HS0 TO HS3
Output Rising Medium Slew Rate (medium speed slew rate / SR[1:0]=00)(23) SRR_00
V/μs
VPWR = 14V
0.2
0.4
0.8
Output Rising Slow Slew Rate (low speed slew rate / SR[1:0]=01)(23)
VPWR = 14V
SRR_01
V/μs
0.1
0.2
0.4
Output Falling Fast Slew Rate (high speed slew rate / SR[1:0]=10)(23)
VPWR = 14V
SRR_10
V/μs
0.4
0.8
1.6
Output Falling Medium Slew Rate (medium speed slew rate / SR[1:0]=00)(23) SRF_00
V/μs
VPWR = 14V
0.2
0.4
0.8
Output Falling Slow Slew Rate (low speed slew rate / SR[1:0]=01)(23)
VPWR = 14V
SRF_01
V/μs
0.1
0.2
0.4
Output Rising Fast Slew Rate (high speed slew rate / SR[1:0]=10)(23)
VPWR = 14V
SRF_10
V/μs
0.4
0.8
1.6
Output Turn-ON Delay Time(24)
VPWR = 14V for medium speed slew rate (SR[1:0]=00)
t DLY(ON)
μs
35
60
85
Output Turn-OFF Delay Time(25)
VPWR = 14V for medium speed slew rate (SR[1:0]=00)
t DLY(OFF)
μs
35
60
85
Driver Output Matching Slew Rate (SRR /SRF)
VPWR = 14V @ 25°C and for medium speed slew rate (SR[1:0]=00)
Δ SR
0.8
1.0
1.2
Driver Output Matching Time (t DLY(ON) - t DLY(OFF))
Δ t RF
μs
VPWR = 14V, f PWM = 240Hz, PWM duty cycle = 50%, @ 25°C for medium
speed slew rate (SR[1:0]=00)
-25
0
25
Notes
23. Rise and Fall Slew Rates measured across a 5.0Ω resistive load at high side output = 30% to 70% (see Figure 4, page 14).
24. Turn-ON delay time measured from rising edge of any signal (IN[0:3] and CS) that would turn the output ON to VHS[0:3] = VPWR / 2 with
RL = 5.0Ω resistive load.
25. Turn-OFF delay time measured from falling edge of any signal (IN[0:3] and CS) that would turn the output OFF to VHS[0:3] =VPWR / 2
with RL = 5.0Ω resistive load.
35XS3400
10
Analog Integrated Circuit Device Data
Freescale Semiconductor