CH7003B Datasheet, PDF (28/50 Pages) List of Unclassifed Manufacturers – Digital PC to TV Encoder

CHRONTEL
Transfer Protocols (continued)
.
CH7003B
CH7003
CH7003
acknowledge
acknowledge
SD
CH7003
acknowedge
Master
does not
acknowledge
I²C
I²C
SC
1-7
8
9
1-8
9
10
1-7
8
9
1-8
9
10
Start Device ID R/W* ACK
Condition
RAB ₁
ACK Restart Device ID R/W* ACK
Condition
Data ₁
ACK Restart
Condition
CH7003
acknowledge
CH7003
acknowledge
CH7003
acknowledge
Master does
not acknowledge
I²C
I²C
1-7
8
9
1-8
9
10
1-7
8
9
1-8
9
Device ID
R/W* ACK
RAB ₂
ACK Restart Device ID R/W* ACK
Condition
Data ₂
ACK
Stop
Condition
Figure 24: Alternating Read Cycle
If AutoInc = 1, then the address register will be incremented automatically and subsequent data bytes can be read
from successive registers, without providing a second RAB.
CH7003
acknowledge
CH7003
SD
CH7003
acknowledge
Master
acknowledge
Master does
not acknowledge
just before Stop
condition
I²C
I²C
SC
1-7
8
9
1-8
9
10
1-7
8
9
1-8
9
1-8
9
Start
Condition
Device ID
R/W*
ACK
RAB _n
ACK Restart Device ID R/W* ACK
Condition
Data _n
ACK
Data
n+1
ACK
Stop
Condition
Figure 25: Auto-increment Read Cycle
When the auto-increment mode is enabled (AutoInc is set to 1), the Address Register will continue incrementing for
each read cycle. When the content of the Address Register reaches 2A, it will wrap around and start from 00h again.
The auto increment sequence can be terminated by either a “STOP” or “RESTART” condition. The read operation
can be terminated with a “STOP” condition. Figure 25 shows an auto-increment read cycle terminated by a STOP or
RESTART condition.
28
201-0000-023 Rev.4.1, 8/2/99