AMC1210 Datasheet, PDF (2/47 Pages) Burr-Brown (TI) – Quad Digital Filter for 2nd-Order Delta-Sigma Modulator

AMC1210
SBAS372A – APRIL 2006 – REVISED OCTOBER 2006
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be
more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
ORDERING INFORMATION⁽¹⁾
PRODUCT
AMC1210
PACKAGE
PACKAGE-LEAD DESIGNATOR
SPECIFIED
TEMPERATURE
RANGE
QFN-40
RHA
–40°C to +125°C
PACKAGE
MARKING
AMC1210I
ORDERING
NUMBER
AMC1210IRHAT
AMC1210IRHAR
TRANSPORT
MEDIA,
QUANTITY
Tape and Reel, 250
Tape and Reel, 2500
(1) For the most current specifications and package information, see the Package Option Addendum located at the end of this data sheet or
refer to our web site at www.ti.com.
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range (unless otherwise noted)⁽¹⁾
Supply voltage, all supplies (AVDD, BVDD, CVDD, DVDD) to GND
Digital input to GND
Ground voltage difference, AGND to GND
Input current to any pin except supply
Power dissipation
Operating virtual junction temperature range, T_J
Operating free-air temperature range, T_A
Storage temperature range, T_STG
Lead temperature, 1,6mm (1/16-inch) from case for 10 seconds
AMC1210
UNIT
–0.3 to +6
V
GND – 0.3 to BVDD + 0.3
V
±0.3
V
–10 to +10
mA
See Dissipation Ratings Table
–40 to +150
°C
–40 to +125
°C
–65 to +150
°C
+260
°C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under the Electrical Characteristics
is not implied. Exposure to absolute maximum rated conditions for extended periods may affect device reliability.
DISSIPATION RATINGS
PACKAGE
RHA ⁽¹⁾
T_A ≤ +25°C
POWER RATING
3787mW
DERATING FACTOR
ABOVE T_A = +25°C
30.3mW/°C
T_A = +70°C
POWER RATING
2424mW
(1) The thermal resistance (junction-to-ambient) of the RHA package is 32°C/W.
T_A = +85°C
POWER RATING
1969mW
T_A = +125°C
POWER RATING
758mW
2
Submit Documentation Feedback