82-000770-01 Datasheet, PDF (90/91 Pages) Analog Devices – ADSP-TS201S EZ-KIT Lite Evaluation System

INDEX
M
master processors, 2-10
memory
map, of this EZ-KIT Lite, 1-7
select pins, See ~BMS, ~MS0, 1-7
microphones, 2-5
~MS0 memory bank 0 select pins, 1-7, 1-8, 2-3
MSSD0 external memory space, 1-8
resistors
diagram of locations, 2-10
clock mode settings, 2-12
control impedance selection, 2-14
drive strength selection, 2-15
processor ID settings, 2-11
restrictions, of the license, 1-7
RJ-45 connectors, 1-12, 2-23
RX port, 1-12
N
notation conventions, xxi
O
oscillators (U18), 2-3, 2-12
P
package contents, 1-2
power
connector (J8), 2-21
LED (LED1), 2-16
regulators, 2-2
supply specifications, 2-23
processor IDs, 1-8, 1-12, 2-10, 2-15
programmable flag pins, See flags by name
(FLAGs)
push buttons
See also push buttons by name (SWx)
diagram of locations, 2-16
R
registration, of this product, 1-3
reset
master (LED8), 2-16
processor, 2-6
push button (SW3), 2-19
S
schematic, of this EZ-KIT Lite, B-1
SCLK pins, 2-14
SCLKRAT2-0 pins, 2-3, 2-12, 2-13
SDRAM
interface, 1-8
start/end addresses, 1-8
SDRCON registers, 1-8, 2-7
setup, of this EZ-KIT Lite, 1-4
SOC registers, 1-8
specifications, of the power supply, 2-23
SQSTAT registers, 1-10
startup, of this EZ-KIT Lite, 1-5
SW10 (FLAG/IRQ) DIP switch, 2-9
SW1 (audio amplification) switch, 2-5
SW2 DIP switch, 2-7, 2-8
SW3 (reset) push button, 2-19
SW4 (IRQ0_A) push button, 1-11, 2-19
SW5 (IRQ0_B) push button, 1-11, 2-19
SW6 (FLAG0_B) push button, 1-11, 2-18
SW7 (FLAG1_B) push button, 1-11, 2-18
SW8 (FLAG1_A) push button, 1-11, 2-18
SW9 (FLAG0_A) push button, 1-11, 2-18
SYSCON registers, 1-8, 2-7
system architecture, of this EZ-KIT Lite, 2-2
T
TX port, 1-12
ADSP-TS201S EZ-KIT Lite Evaluation System Manual
I-3