82-000770-01 Datasheet, PDF (27/91 Pages) Analog Devices – ADSP-TS201S EZ-KIT Lite Evaluation System

Using ADSP-TS201S EZ-KIT Lite
Installation and Session Startup
L For correct operation, install the software and hardware in the
order presented in the VisualDSP++ Installation Quick Reference
Card.
1. Verify that the yellow USB monitor LED (ZLED3, located near the
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run VisualDSP++.
2. If you are running VisualDSP++ for the first time, navigate to the
VisualDSP++ environment via the Start –> Programs menu. The
main window appears. Note that VisualDSP++ does not connect to
any session. Skip the rest of this step to step 3.
If you have run VisualDSP++ previously, the last opened session
appears on the screen. You can override the default behavior and
force VisualDSP++ to start a new session by pressing and holding
down the Ctrl key while starting VisualDSP++. Do not release the
Ctrl key until the Session Wizard appears on the screen. Go to
step 4.
3. To connect to a new EZ-KIT Lite session, start Session Wizard by
selecting one of the following.
• From the Session menu, New Session.
• From the Session menu, Session List. Then click New Ses-
sion from the Session List dialog box.
• From the Session menu, Connect to Target. Then click
New Session from the Session List dialog box.
4. The Select Processor page of the wizard appears on the screen.
Ensure TigerSHARC is selected in Processor family. In Choose a
target processor, select ADSP-TS201. Click Next.
ADSP-TS201S EZ-KIT Lite Evaluation System Manual
1-5