82-000770-01 Datasheet, PDF (11/91 Pages) Analog Devices – ADSP-TS201S EZ-KIT Lite Evaluation System

Preface
• Flash memory
D 512K main flash memory
• USB debugging interface
• Interface connectors
D 14-pin emulator connector for JTAG interface
D Low Voltage Differential Signaling (LVDS) link ports via
RJ-45 connectors
D Expansion interface connectors
• General-purpose IO
D 4 push button flags (two for each processor)
D 2 push button interrupts (one for each processor)
D 4 LED FLAG outputs (two for each processor)
• Analog Devices ADP3331, ADP3336, ADP1864, ADP1821, and
ADP1823 voltage regulators
The EZ-KIT Lite board contains two external memories: flash memory
and SDRAM. The flash memory can be used to store user-specific boot
code. By configuring the boot mode switch (SW2) and programming the
flash memory, the board can run as a stand-alone unit. The SDRAM is
shared by both processors and can be used to store data external to the
processors. For more information, see “Memory Map” on page 1-7.
The EZ-KIT Lite board contains an audio interface, facilitating creation
of audio signal processing applications.
Additionally, the EZ-KIT Lite board provides expansion connectors,
allowing you to connect to the processor’s external port (EP).
ADSP-TS201S EZ-KIT Lite Evaluation System Manual
xi