82-000770-01 Datasheet, PDF (42/91 Pages) Analog Devices – ADSP-TS201S EZ-KIT Lite Evaluation System

Switch Settings
Table 2-2. Audio Amplification Selection (SW1)
Position 1
OFF
ON
Position 2
OFF
ON
Position 3
ON
OFF
Position 4
ON
OFF
Audio Amplification Mode
No amplification (default)
For electret microphone use
Processor Mode Selections (SW2)
The SW2 switch configures several processor strap pins, which in turn, set
the processor’s operating modes after power up or hard reset:
• “Processor Boot Strap Settings”
• “SYSCON/SDRCON Mode Settings”
• “Interrupt Enable Settings”
• “Link Port Width Settings”
Do not change the switch settings while power is being applied to the
board. Many of the strap pin settings can be re-configured in software
after the processor is powered up. Refer to the ADSP-TS201S processor
data sheet at http://www.analog.com/Uploaded-
Files/Data_Sheets/ADSP_TS201S.pdf for more information.
2-6
ADSP-TS201S EZ-KIT Lite Evaluation System Manual