82-000770-01 Datasheet, PDF (46/91 Pages) Analog Devices – ADSP-TS201S EZ-KIT Lite Evaluation System

Configuration Resistors
Configuration Resistors
This section describes the configuration resistors of the two TigerSHARC
processors. The locations of the configuration resistors and their respective
default settings are shown in Figure 2-3.
Figure 2-3. Resistor Locations (Bottom View of the Board)
Processor ID Settings
The two ADSP-TS201S processors on the EZ-KIT Lite are factory-config-
ured to set the processor A to an ID value of zero and processor B to an ID
value of one. This means that in the cluster, processor A is the master.
2-10
ADSP-TS201S EZ-KIT Lite Evaluation System Manual