W83627EHF_0611 Datasheet, PDF (76/144 Pages) Winbond – WINBOND LPC I/O

W83627EHF/EF, W83627EHG/EG
Bit 7: BEEP output control for CPUFANIN0 if the monitor value exceed the limit value. Write 1, enable
BEEP output. Write 0, disable BEEP output, which is default value.
Bit 6: BEEP output control for SYSFANIN if the monitor value exceed the limit value. Write 1, enable
BEEP output. Write 0, disable BEEP output, which is default value.
Bit 5: BEEP output control for temperature CPUTIN if the monitor value exceed the limit value. Write 1,
enable BEEP output. Write 0, disable BEEP output, which is default value.
Bit 4: BEEP output control for temperature SYSTIN if the monitor value exceed the limit value. Write 1,
enable BEEP output. Write 0, disable BEEP output, which is default value.
Bit 3: BEEP output control for 3VCC if the monitor value exceed the limit value. Write 1, enable BEEP
output. Write 0, disable BEEP output, which is default value.
Bit 2: BEEP output control for AVCC if the monitor value exceed the limit value. Write 1, enable BEEP
output. Write 0, disable BEEP output, which is default value.
Bit 1: BEEP output control for VIN0 if the monitor value exceed the limit value. Write 1, enable BEEP
output. Write 0, disable BEEP output, which is default value.
Bit 0: BEEP output control for CPUVCORE if the monitor value exceed the limit value. Write 1, enable
BEEP output. Write 0, disable BEEP output, which is default value.
6.8.50 BEEP Control Register 2 - Index 57h (Bank 0)
Register Location:
57h
Power on Default Value:
80h
Attribute:
Read/Write
Size:
8 bits
7 6 5 4 32 1 0
EN_VIN1_BP
EN_VIN2_BP
EN_VIN3_BP
EN_AUXFANIN0_BP
EN_CASEOPEN_BP
EN_AUXTIN_BP
Reserved
EN_GBP
Bit 7: Global BEEP Control. Write 1, enable global BEEP output, which is default value. Write 0,
disable all BEEP output.
Bit 6: Reserved.
Bit 5: BEEP output control for temperature AUXTIN if the monitor value exceed the limit value. Write 1,
enable BEEP output. Write 0, disable BEEP output, which is default value.
Bit 4: BEEP output control for CASEOPEN if case has been opened. Write 1, enable BEEP output.
Write 0, disable BEEP output, which is default value.
Bit 3: BEEP output control for AUXFANIN0 if the monitor value exceed the limit value. Write 1, enable
BEEP output. Write 0, disable BEEP output, which is default value.
Bit 2: BEEP output control for VIN3 if the monitor value exceed the limit value. Write 1, enable BEEP
output. Write 0, disable BEEP output, which is default value.
Bit 1: BEEP output control for VIN2 if the monitor value exceed the limit value. Write 1, enable BEEP
output. Write 0, disable BEEP output, which is default value.
- 70 -