MSP430F23X_14 Datasheet, PDF (80/93 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430F23x
MSP430F24x(1)
MSP430F2410
SLAS547I – JUNE 2007 – REVISED DECEMBER 2012
REVISION HISTORY
www.ti.com
LITERATURE
NUMBER
SLAS547
SLAS547A
SLAS547B
SLAS547C
SLAS547D
SLAS547E
SLAS547F
SLAS547G
SLAS547H
SLAS547I
SUMMARY
Product Preview release
Production Data release
Corrected terminal names and descriptions for pins 34 and 35 in "Terminal Functions - MSP430F23x" (page 9)
Corrected terminal names for pins 13, 14, and 15 in "Terminal Functions - MSP430F24x1" (page 13)
Corrected interrupt source and flag entries for USCI_A1/USCI_B1 in "interrupt vector addresses" table (page 17)
Changed index values from 1-3 to 0-2 in Figures 23 to 26 (pages 52 and 54)
Changed f_max,BITCLK and t_τ parameters in "USCI (UART mode)" table (page 56)
Corrected "Port P1.0 to P1.7 pin functions" table (page 72)
Removed incorrect CAPD.x column in "Port P6.0 to P6.6 pin functions" table (page 80)
Added Development Tool Support section (page 2)
Updated parametric values in "low-power mode supply current into V_CC excluding external current" table (page 34)
Updated notes and t_CMErase MIN value "flash memory" table (page 34)
Changed limits on t_d(SVSon) parameter (page 41)
Changed "Port 6.0 to 6.6 Pin Functions" table (page 77)
Changed "Port 6.7 Pin Functions" table (page 78)
Changed T_stg, Programmed device, to -55°C to 150°C in Absolute Maximum Ratings
Corrected formatting error of T_A column in Active Mode Supply Current (both I_AM,1MHz parameters) and in Low-Power-
Mode Supply Currents (I_LPM0,1MHz and I_LPM0,100kHz parameters)
Corrected number of capture/compare registers in description in Timer_B3 (MSP430F23x Devices).
Added typical test conditions in Recommended Operating Conditions.
Removed "Timer_A3.CCIxA" entries from P1.5 through P1.7 in Table 20.
80
Submit Documentation Feedback
Copyright © 2007–2012, Texas Instruments Incorporated