NS32FV16 Datasheet, PDF (63/104 Pages) Texas Instruments – Advanced Imaging/Communication Signal Processors

3 0 Functional Description (Continued)
At this time the signals TSO (Timing State Output) DBE
a bus cycle Any type of bus cycle except a Slave Processor
(Data Buffer Enable) and either RD (Read Strobe) or WR
cycle and a special bus cycle can be extended
(Write Strobe) will also be activated
In Figures 3-21 and 3-22 note that during T3 all bus control
The T3 state provides for access time requirements and it
signals from the CPU are flat Therefore a bus cycle can be
occurs at least once in a bus cycle At the end of T2 on the
cleanly extended by causing the T3 state to be repeated
rising edge of CTTL the CWAIT signal is sampled to deter-
This is the purpose of the CWAIT input signal
mine whether the bus cycle will be extended See Section
3553
At the end of state T2 on the rising edge of CTTL CWAIT is
sampled
If the CPU is performing a read cycle the data bus (AD0–
CWAIT causes wait states to be inserted continuously as
AD15) is sampled at the beginning of T4 on the rising edge
long as it is sampled active It is normally used when the
of CTTL Data must however be held a little longer to meet
number of wait states to be inserted in the CPU bus cycle is
the data hold time requirements The RD signal is guaran-
not known in advance
teed not to go inactive before this time so its rising edge
can be safely used to disable the device providing the input
data
The following sequence shows the CPU response to the
WAIT1 – 2 and CWAIT inputs
The T4 state finishes the bus cycle At the beginning of T4
the RD or WR and TSO signals go inactive and on the
falling edge of CTTL DBE goes inactive having provided for
necessary data hold times Data during Write cycles re-
mains valid from the CPU throughout T4 Note that the Bus
Status lines (ST0 –ST3) change at the beginning of T4 an-
ticipating the following bus cycle (if any)
3 5 5 3 Cycle Extension
te ^{To allow sufficient access time for any speed of memory or}
Obsole ^{peripheral device the NS32FX164 provides for extension of}
1 Start bus cycle
2 Sample CWAIT at the end of state T2
3 If CWAIT is not active then go to step 6
4 Insert one wait state
5 Sample CWAIT again then go to step 3
6 Complete bus cycle
Figure 3-23 shows a bus cycle extended by three wait
states due to CWAIT
62