DS100MB201_16 Datasheet, PDF (6/26 Pages) Texas Instruments – Dual Lane 2:1/1:2 Mux/Buffer with Equalization

DS100MB201
SNLS333A – APRIL 2011 – REVISED APRIL 2013
www.ti.com
Electrical Characteristics⁽¹⁾ (continued)
Over recommended operating supply and temperature ranges with default register settings unless other specified.
Parameter
Test Conditions
Min
Typ
Max
DIFFERENTIAL OUTPUTS (OUT_n+, OUT_n-)
V_OD
Output Differential Voltage Swing R_L = 50 Ω ±1% to GND (AC coupled with
10 nF), 6.4 Gbps, See⁽⁵⁾
500
600
700
VOD1–0 = 00
V_OCM
Output Common-Mode Voltage
Single-ended measurement DC-Coupled
with 50Ω termination,
See ⁽⁶⁾
V_DD –
1.4
T_TX-RF
Transmitter Rise/ Fall Time
20% to 80% of differential output voltage,
measured within 1” from output pins,
See⁽⁶⁾⁽⁵⁾ and Figure 2
65
85
T_RF-DELTA
Tx rise/fall mismatch
20% to 80% of differential output voltage,
See ^{(6) (5)}
0.1
RL_TX-DIFF
Tx Differential Return Loss
Repeating 1100b (D24.3) pattern,
(SDD22),
VOD = 0.8 Vp-p,
-11
See ⁽⁶⁾
150 MHz – 1.5 GHz
1.5 GHz – 3.0 GHz
-10
3 GHz – 6.0 GHz
-5
RL_TX-CM
Tx Common Mode Return Loss
Repeating 1100b (D24.3) pattern,
(SCC22)
VOD = 0.8 Vp-p, See⁽⁶⁾
-10
50 MHz – 3.0 GHz
R_TX-IB
Tx Impedance Balance
Repeating 1100b (D24.3) pattern,
(SCL22)
VOD = 0.8 Vp-p, See⁽⁶⁾
-30
50 MHz – 3.0 GHz
I_TX-SHORT
R_OTD
R_OTIB
R_OCM
V_TX-CM-DELTA
Tx Output Short Circuit Current
Limit
Output Differential Impedance
between OUT+ and OUT-
Output Differential Impedance
Imbalance
Output Common Mode Impedance
Common Mode Voltage Delta
between active burst and electrical
Idle of an OOB signal
See ⁽⁶⁾
See ⁽⁶⁾
See ⁽⁶⁾
Minimum Temperature for OOB signal
pass-through is -10C.
VIN = 800 mVp-p, at 3 Gbps,
See ⁽⁷⁾
90
85
100
125
5
20
25
35
±40
T_PD
Differential Propagation Delay (Low Propagation delay measure at midpoint
to High and High to Low Edge
crossing between input to outputEQx[1:0] 150
200
250
= 11 Figure 3
EQz[1:0] = OFF
120
170
220
T_LSK
Lane to Lane Skew in a Single Part V_DD = 2.5V, T_A = 25°C
27
T_PPSK
Part to Part Propagation Delay
Skew
V_DD = 2.5V, T_A = 25°C
35
T_SM
Switch/Mux Time
Time to switch/mux between A and B
input/output signals
150
Units
mV_P-P
V
ps
UI
dB
dB
dB
mA
Ω
Ω
Ω
mV
ps
ps
ps
ps
ns
(5) Measured with clock-like {11111 00000} pattern.
(6) Typical values represent most likely parametric norms at V_DD = 2.5V, T_A = 25°C., and at the Recommended Operation Conditions at the
time of product characterization and are not guaranteed.
(7) Common-mode voltage (VCM) is expressed mathematically as the average of the two signal voltages with respect to local ground.VCM
= (A + B) / 2, A = OUT+, B = OUT-.
6
Submit Documentation Feedback
Copyright © 2011–2013, Texas Instruments Incorporated
Product Folder Links: DS100MB201