DRV2605L Datasheet, PDF (57/69 Pages) Texas Instruments – DRV2605L 2 to 5.2 V Haptic Driver for LRA and ERM With Effect Library and Smart-Loop Architecture

www.ti.com
DRV2605L
SLOS854C – MAY 2014 – REVISED SEPTEMBER 2014
Initialization Setup (continued)
9.3.2.3 Play a PWM or Analog Input Waveform
1. Initialize the device as shown in the Initialization Procedure section.
2. Assert the EN pin (active high) if it was previously deasserted.
3. If register 0x01 already holds the desired value and the STANDBY bit is low, the user can skip this step. Set
the MODE value to 3 (PWM/Analog Mode) at address 0x01. If the STANDBY bit was previously asserted,
this bit should be deasserted (logic low) at this time.
4. Select the input mode (PWM or analog) in the Control3 register (address 0x1D). If this mode was selected
during the initialization procedure, the user can skip this step.
5. Send the desired PWM or analog input waveform sequence from the external source. See the Data Formats
for Waveform Playback section for drive amplitude scaling.
6. When the desired drive sequence is complete, put the device in low-power mode by deasserting the EN pin
or setting the STANDBY bit.
10 Power Supply Recommendations
The DRV2605L device is designed to operate from an input-voltage supply range between 2 V to 5.2 V. The
decoupling capacitor for the power supply should be placed closed to the device pin.
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: DRV2605L
Submit Documentation Feedback
57