COP888CL Datasheet, PDF (29/42 Pages) Texas Instruments – COP888CL 8-Bit Microcontroller

Addressing Modes (Continued)
Absolute Long
This mode is used with the JMPL and JSRL instructions, with
the instruction field of 15 bits replacing the entire 15 bits of
the program counter (PC). This allows jumping to any loca-
tion in the current 4k program memory space.
Indirect
This mode is used with the JID instruction. The contents of
the accumulator are used as a partial address (lower 8 bits of
PC) for accessing a location in the program memory. The
Instruction Set
Register and Symbol Definition
Registers
A
8-Bit Accumulator Register
B
8-Bit Address Register
X
8-Bit Address Register
SP
8-Bit Stack Pointer Register
PC
15-Bit Program Counter Register
PU
Upper 7 Bits of PC
PL
Lower 8 Bits of PC
C
1 Bit of PSW Register for Carry
HC
1 Bit of PSW Register for Half Carry
GIE
1 Bit of PSW Register for Global Interrupt
Enable
VU
Interrupt Vector Upper Byte
VL
Interrupt Vector Lower Byte
[B]
[X]
MD
Mem
Meml
Imm
Reg
Bit
←
↔
Symbols
Memory Indirectly Addressed by B Register
Memory Indirectly Addressed by X Register
Direct Addressed Memory
Direct Addressed Memory or [B]
Direct Addressed Memory or [B] or
Immediate Data
8-Bit Immediate Data
Register Memory: Addresses F0 to FF
(Includes B, X and SP)
Bit Number (0 to 7)
Loaded with
Exchanged with
contents of this program memory location serve as a partial
address (lower 8 bits of PC) for the jump to the next instruc-
tion.
Note: The VIS is a special case of the Indirect Transfer of Control addressing
mode, where the double byte vector associated with the interrupt is
transferred from adjacent addresses in the program memory into the
program counter (PC) in order to jump to the associated interrupt
service routine.
www.national.com
28