OMAPL137DZKB3 Datasheet, PDF (34/223 Pages) Texas Instruments – OMAP-L137 Low-Power Applications Processor

OMAP-L137
SPRS563F – SEPTEMBER 2008 – REVISED FEBRUARY 2013
www.ti.com
2.7.7 Enhanced Capture/Auxiliary PWM Modules (eCAP0, eCAP1, eCAP2)
The eCAP Module pins function as either input captures or auxilary PWM 32-bit outputs, depending upon
how the eCAP module is programmed.
Table 2-11. Enhanced Capture Module (eCAP) Terminal Functions
SIGNAL NAME
PIN
NO
ZKB
TYPE ⁽¹⁾
PULL ⁽²⁾
MUXED
DESCRIPTION
eCAP0
ACLKX0/ECAP0/APWM0/GP2[12]
C5
I/O
IPD McASP0, GPIO
enhanced capture 0
input or auxiliary
PWM 0 output
eCAP1
ACLKR0/ECAP1/APWM1/GP2[15]
B4
I/O
IPD McASP0, GPIO
enhanced capture 1
input or auxiliary
PWM 1 output
eCAP2
ACLKR1/ECAP2/APWM2/GP4[12]
L2
I/O
IPD McASP1, GPIO
enhanced capture 2
input or auxiliary
PWM 2 output
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (ie., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor
34
Device Overview
Submit Documentation Feedback
Product Folder Links: OMAP-L137
Copyright © 2008–2013, Texas Instruments Incorporated