OMAPL137DZKB3 Datasheet, PDF (33/223 Pages) Texas Instruments – OMAP-L137 Low-Power Applications Processor

OMAP-L137
www.ti.com
SPRS563F – SEPTEMBER 2008 – REVISED FEBRUARY 2013
2.7.6 Serial Peripheral Interface Modules (SPI0, SPI1)
Table 2-10. Serial Peripheral Interface (SPI) Terminal Functions
SIGNAL NAME
PIN
NO
ZKB
TYPE ⁽¹⁾
PULL ⁽²⁾
MUXED
DESCRIPTION
SPI0
SPI0_SCS[0] /UART0_RTS/EQEP0B/GP5[4]/BOOT[4]
N4
I/O
IPU
UART0, EQEP0B,
GPIO, BOOT
SPI0 chip select
SPI0_ENA /UART0_CTS/EQEP0A/GP5[3]/BOOT[3]
R5
I/O
IPU
UART0, EQEP0A,
GPIO, BOOT
SPI0 enable
SPI0_CLK/EQEP1I/GP5[2]/BOOT[2]
T5
I/O
IPD eQEP1, GPIO, BOOT SPI0 clock
SPI0_SIMO[0]/EQEP0S/GP5[1]/BOOT[1]
SPI0_SOMI[0]/EQEP0I/GP5[0]/BOOT[0]
P6
I/O
R6
I/O
IPD
SPI0 data slave-in-
master-out
eQEP0, GPIO, BOOT
IPD
SPI0 data slave-out-
master-in
SPI1
SPI1_SCS[0] /UART2_TXD/GP5[13]
SPI1_ENA /UART2_RXD/GP5[12]
P4
I/O
R4
I/O
IPU
UART2, GPIO
IPU
SPI1 chip select
SPI1 enable
SPI1_CLK/EQEP1S/GP5[7]/BOOT[7]
T6
I/O
IPD eQEP1, GPIO, BOOT SPI1 clock
SPI1_SIMO[0]/I2C1_SDA/GP5[6]/BOOT[6]
SPI1_SOMI[0]/I2C1_SCL/GP5[5]/BOOT[5]
N5
I/O
P5
I/O
IPU
SPI1 data slave-in-
master-out
I2C1, GPIO, BOOT
IPU
SPI1 data slave-out-
master-in
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (ie., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor
Copyright © 2008–2013, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: OMAP-L137
Device Overview
33