CD00001237 Datasheet, PDF (64/105 Pages) STMicroelectronics – 8-bit MCUs with A/D converter

ST6215C ST6225C
11.2 ABSOLUTE MAXIMUM RATINGS
Stresses above those listed as “absolute maxi-
mum ratings” may cause permanent damage to
the device. This is a stress rating only and func-
tional operation of the device under these condi-
11.2.1 Voltage Characteristics
tions is not implied. Exposure to maximum rating
conditions for extended periods may affect device
reliability.
Symbol
V_DD - V_SS
V_IN
V_OUT
V_ESD(HBM)
Ratings
Supply voltage
Input voltage on any pin ^{1) & 2)}
Output voltage on any pin ^{1) & 2)}
Electro-static discharge voltage (Human Body Model)
Maximum value
7
V_SS-0.3 to V_DD+0.3
V_SS-0.3 to V_DD+0.3
3500
Unit
V
11.2.2 Current Characteristics
Symbol
I_VDD
I_VSS
Ratings
Maximum value
Unit
Total current into V_DD power lines (source) ³⁾
80
Total current out of V_SS ground lines (sink) ³⁾
100
Output current sunk by any standard I/O and control pin
20
I_IO
Output current sunk by any high sink I/O pin
Output current source by any I/Os and control pin
40
mA
15
I_INJ(PIN) ^{2) & 4)}
Injected current on RESET pin
Injected current on any other pin
±5
±5
11.2.3 Thermal Characteristics
Symbol
T_STG
T_J
Ratings
Storage temperature range
Maximum junction temperature
(see THERMAL CHARACTERISTICS section)
Value
Unit
-60 to +150
°C
Notes:
1. Directly connecting the RESET and I/O pins to V_DD or V_SS could damage the device if an unintentional internal reset
is generated or an unexpected change of the I/O configuration occurs (for example, due to a corrupted program coun-
ter). To guarantee safe operation, this connection has to be done through a pull-up or pull-down resistor (typical: 4.7kΩ
for RESET, 10kΩ for I/Os). Unused I/O pins must be tied in the same way to V_DD or V_SS according to their reset con-
figuration.
2. When the current limitation is not possible, the V_IN absolute maximum rating must be respected, otherwise refer to
I_INJ(PIN) specification. A positive injection is induced by V_IN>V_DD while a negative injection is induced by V_IN<V_SS.
3. Power (V_DD) and ground (V_SS) lines must always be connected to the external supply.
4. Negative injection disturbs the analog performance of the device. In particular, it induces leakage currents throughout
the device including the analog inputs. To avoid undesirable effects on the analog functions, care must be taken:
- Analog input pins must have a negative injection less than 1mA (assuming that the impedance of the analog voltage
is lower than the specified limits).
- Pure digital pins must have a negative injection less than 1mA. In addition, it is recommended to inject the current as
far as possible from the analog input pins.
64/105
1