LSM330DL Datasheet, PDF (47/54 Pages) STMicroelectronics – Linear sensor module 3D accelerometer sensor and 3D gyroscope sensor

LSM330DL
Registers description
7.38
INT1_SRC_G (31h)
The interrupt source register is a read-only register.
Reading at this address clears the INT1_SRC_G IA bit (and eventually the interrupt signal
on the INT1_G pin) and allows the refreshment of data in the INT1_SRC_G register if the
latched option was chosen.
Table 92. INT1_SRC_G register
0⁽¹⁾
IA
ZH
ZL
YH
YL
XH
XL
1. This bit has to be set to ‘0’ for correct operation.
Table 93. INT1_SRC_G description
Interrupt active. Default value: 0
IA
(0: no interrupt has been generated; 1: one or more interrupts have been generated)
ZH
Z high. Default value: 0 (0: no interrupt, 1: Z high event has occurred)
ZL
Z low. Default value: 0 (0: no interrupt; 1: Z low event has occurred)
YH
Y high. Default value: 0 (0: no interrupt, 1: Y high event has occurred)
YL
Y low. Default value: 0 (0: no interrupt, 1: Y low event has occurred)
XH
X high. Default value: 0 (0: no interrupt, 1: X high event has occurred)
XL
X low. Default value: 0 (0: no interrupt, 1: X low event has occurred)
7.39
INT1_THS_XH_G (32h)
Table 94. INT1_THS_XH_G register
--
THSX14 THSX13 THSX12 THSX11 THSX10
THSX9
THSX8
Table 95. INT1_THS_XH_G description
THSX14 - THSX9 Interrupt threshold. Default value: 0000 0000
7.40
INT1_THS_XL_G (33h)
Table 96. INT1_THS_XL_G register
THSX7 THSX6 THSX5 THSX4
THSX3
THSX2
THSX1
THSX0
Table 97. INT1_THS_XL_G description
THSX7 - THSX0 Interrupt threshold. Default value: 0000 0000
Doc ID 022018 Rev 1
47/54