LAN9118_07 Datasheet, PDF (79/129 Pages) SMSC Corporation – High Performance Single-Chip 10/100 Non-PCI Ethernet Controller

High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
BITS DESCRIPTION
0 Soft Reset (SRST). Writing 1 generates a software initiated reset. This reset
generates a full reset of the MAC CSR’s. The SCSR’s (system command
and status registers) are reset except for any NASR bits. Soft reset also
clears any TX or RX errors (TXE/RXE). This bit is self-clearing.
Notes:
„ Do not attempt a soft reset unless the internal PHY is fully awake and
operational. After a PHY reset, or when returning from a reduced power
state, the PHY must be given adequate time to return to the operational
state before a soft reset can be issued. The internal RX_CLK and TX_CLK
signals must be running for a proper software reset. Please refer to
Section 6.8, "Reset Timing," on page 121 for details on PHY reset timing.
„ The LAN9118 must always be read at least once after power-up, reset, or
upon return from a power-saving state or write operations will not function.
TYPE
SC
DEFAULT
0
5.3.9.1
Allowable settings for Configurable FIFO Memory Allocation
TX and RX FIFO space is configurable through the CSR - HW_CFG register defined above. The user
must select the FIFO allocation by setting the TX FIFO Size (TX_FIF_SZ) field in the hardware
configuration (HW_CFG) register. The TX_FIF_SZ field selects the total allocation for the TX data path,
including the TX Status FIFO size. The TX Status FIFO size is fixed at 512 Bytes (128 TX Status
DWORDs). The TX Status FIFO length is subtracted from the total TX FIFO size with the remainder
being the TX data FIFO Size. Note that TX data FIFO space includes both commands and payload
data.
RX FIFO Size is the remainder of the unallocated FIFO space (16384 bytes – TX FIFO Size). The RX
Status FIFO size is always equal to 1/16 of the RX FIFO Size. The RX Status FIFO length is subtracted
from the total RX FIFO size with the remainder being the RX data FIFO Size.
For example, if TX_FIF_SZ = 6 then:
Total TX FIFO Size = 6144 Bytes (6KB)
TX Status FIFO Size = 512 Bytes (Fixed)
TX Data FIFO Size = 6144 – 512 = 5632 Bytes
RX FIFO Size = 16384 – 6144 = 10240 Bytes (10KB)
RX Status FIFO Size = 10240 / 16 = 640 Bytes (160 RX Status DWORDs)
RX Data FIFO Size = 10240 – 640 = 9600 Bytes
Table 5.3 shows every valid setting for the TX_FIF_SZ field. Note that settings not shown in this table
are reserved and should not be used.
Note: The RX data FIFO is considered full 4 DWORDs before the length that is specified in the
HW_CFG register.
TX_FIF_SZ
2
3
SMSC LAN9118
Table 5.3 Valid TX/RX FIFO Allocations
TX DATA FIFO
SIZE (BYTES)
1536
2560
TX STATUS FIFO
SIZE (BYTES)
512
512
RX DATA FIFO
SIZE (BYTES)
13440
12480
79
DATASHEET
RX STATUS FIFO
SIZE (BYTES)
896
832
Revision 1.3 (05-31-07)