LAN9118_07 Datasheet, PDF (118/129 Pages) SMSC Corporation – High Performance Single-Chip 10/100 Non-PCI Ethernet Controller

High Performance Single-Chip 10/100 Non-PCI Ethernet Controller
Datasheet
FIFO_SEL
A[2:1]
nCS, nRD
Data Bus
Figure 6.4 RX Data FIFO Direct PIO Burst Read Cycle Timing
Note: The “Data Bus” width is 32 bits with optional support for 16-bit bus widths
Table 6.6 RX Data FIFO Direct PIO Burst Read Cycle Timing
SYMBOL
t_csh
t_csdv
t_acyc
t_asu
t_adv
t_ah
t_don
t_doff
t_doh
DESCRIPTION
nCS, nRD Deassertion Time
nCS, nRD Valid to Data Valid
Address Cycle Time
Address, FIFO_SEL Setup to nCS, nRD Valid
Address Stable to Data Valid
Address, FIFO_SEL Hold Time
Data Buffer Turn On Time
Data Buffer Turn Off Time
Data Output Hold Time
MIN
TYP
13
45
0
0
0
0
MAX
30
UNITS
ns
ns
ns
40
ns
ns
7
ns
ns
Note: An RX Data FIFO Direct PIO Burst Read cycle begins when both nCS and nRD are asserted.
The cycle ends when either or both nCS and nRD are deasserted. They may be asserted and
deasserted in any order.
6.6
PIO Writes
PIO writes are used for all LAN9118 write cycles. PIO writes can be performed using Chip Select (nCS)
or Write Enable (nWR). Either or both of these control signals must go high between cycles for the
period specified.
PIO Writes are valid for 16- and 32-bit access. Timing for 16-bit and 32-bit PIO write cycles are
identical with the exception that D[31:16] are ignored during a 16-bit write.
Revision 1.3 (05-31-07)
118
DATASHEET
SMSC LAN9118