SI47XX-EVB Datasheet, PDF (35/164 Pages) Silicon Laboratories – Thank you for purchasing the Silicon Laboratories

Si47xx-EVB
4.2.3.3. Default Mode
There are two or more default modes possible for each function.
Use Last UI State: When selected, the GUI will restore all settings on the device to the previous settings
configured in the GUI the last time it was closed.
Use Chip Defaults: When selected, the GUI will use the settings that were default in the firmware on the
device. Only properties related to the correct setting of RCLK (such as frequency and prescaling) and initial
tuning (such as frequency) will be changed. If an error occurs during initialization of a function, choose this
setting to default the GUI settings back to the chip defaults.
Saved Configuration States: If you have previously saved or imported any configuration states, they will be
listed by name. When one of these is selected, the GUI will restore all settings on the device to the
previously saved settings.
4.2.3.4. Audio Mode
This option allows the user to change between Analog or Digital modes if the board connected supports digital.
Sections 2.1.4, 5, 6, and 7 each document the possible settings in more detail depending on what function is being
configured.
Figure 28 displays the window after the Details button has been pressed which helps with selection of the Audio
Mode by displaying a bitmap of the current audio setting in the dialog.
Figure 28. Expanded Details Dialog
4.2.3.5. Firmware
This selection is only required if "From File" was chosen for the Boot Mode. Use this setting to choose which
firmware will be downloaded to the device. If this item turns red then there is no firmware available for the function
so "From Device" must be chosen as the Boot Mode.
Rev. 0.8
35