C8051F340-GQR Datasheet, PDF (155/276 Pages) Silicon Laboratories – Full Speed USB Flash MCU Family

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D
SFR Definition 15.16. P3: Port3 Latch
R/W
P3.7
Bit7
R/W
P3.6
Bit6
R/W
P3.5
Bit5
R/W
P3.4
Bit4
R/W
P3.3
Bit3
R/W
P3.2
Bit2
R/W
R/W
Reset Value
P3.1
P3.0 11111111
Bit1
Bit0 SFR Address:
(bit addressable) 0xB0
Bits7–0:
P3.[7:0]
Write - Output appears on I/O pins.
0: Logic Low Output.
1: Logic High Output (high impedance if corresponding P3MDOUT.n bit = 0).
Read - Always reads ‘0’ if selected as analog input in register P3MDIN. Directly reads Port
pin when configured as digital input.
0: P3.n pin is logic low.
1: P3.n pin is logic high.
Note: P3.1–3.7 are only available on 48-pin devices.
SFR Definition 15.17. P3MDIN: Port3 Input Mode
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
11111111
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 SFR Address:
0xF4
Bits7–0:
Analog Input Configuration Bits for P3.7–P3.0 (respectively).
Port pins configured as analog inputs have their weak pull-up, digital driver, and digital
receiver disabled.
0: Corresponding P3.n pin is configured as an analog input.
1: Corresponding P3.n pin is not configured as an analog input.
Note: P3.1–3.7 are only available on 48-pin devices.
SFR Definition 15.18. P3MDOUT: Port3 Output Mode
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 SFR Address:
0xA7
Bits7–0:
Output Configuration Bits for P3.7–P3.0 (respectively); ignored if corresponding bit in regis-
ter P3MDIN is logic 0.
0: Corresponding P3.n Output is open-drain.
1: Corresponding P3.n Output is push-pull.
Note: P3.1–3.7 are only available on 48-pin devices.
Rev. 1.3
155