C8051F340-GQR Datasheet, PDF (132/276 Pages) Silicon Laboratories – Full Speed USB Flash MCU Family

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D
14.1. Programmable Internal High-Frequency (H-F) Oscillator
All C8051F34x devices include a programmable internal oscillator that defaults as the system clock after a
system reset. The internal oscillator period can be programmed via the OSCICL register shown in SFR
Definition 14.2. The OSCICL register is factory calibrated to obtain a 12 MHz internal oscillator frequency.
Electrical specifications for the precision internal oscillator are given in Table 14.1 on page 141. Note that
the system clock may be derived from the programmed internal oscillator divided by 1, 2, 4, or 8, as
defined by the IFCN bits in register OSCICN. The divide value defaults to 8 following a reset.
14.1.1. Internal H-F Oscillator Suspend Mode
The internal high-frequency oscillator may be placed in Suspend mode by writing ‘1’ to the SUSPEND bit in
register OSCICN. In Suspend mode, the internal H-F oscillator is stopped until a non-idle USB event is
detected (Section 16) or VBUS matches the polarity selected by the VBPOL bit in register REG0CN (Sec-
tion 8.2). Note that the USB transceiver can still detect USB events when it is disabled.
SFR Definition 14.1. OSCICN: Internal H-F Oscillator Control
R/W
R
R/W
R
R/W
R/W
R/W
R/W
Reset Value
IOSCEN IFRDY SUSPEND -
-
-
IFCN1 IFCN0 10000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 SFR Address:
0xB2
Bit7:
Bit6:
Bit5:
Bits4–2:
Bits1–0:
IOSCEN: Internal H-F Oscillator Enable Bit.
0: Internal H-F Oscillator Disabled.
1: Internal H-F Oscillator Enabled.
IFRDY: Internal H-F Oscillator Frequency Ready Flag.
0: Internal H-F Oscillator is not running at programmed frequency.
1: Internal H-F Oscillator is running at programmed frequency.
SUSPEND: Force Suspend
Writing a ‘1’ to this bit will force the internal H-F oscillator to be stopped. The oscillator will be
re-started on the next non-idle USB event (i.e., RESUME signaling) or VBUS interrupt event
(see SFR Definition 8.1).
UNUSED. Read = 000b, Write = don't care.
IFCN1–0: Internal H-F Oscillator Frequency Control.
00: SYSCLK derived from Internal H-F Oscillator divided by 8.
01: SYSCLK derived from Internal H-F Oscillator divided by 4.
10: SYSCLK derived from Internal H-F Oscillator divided by 2.
11: SYSCLK derived from Internal H-F Oscillator divided by 1.
132
Rev. 1.3