R0E00008AKCE00EP62 Datasheet, PDF (77/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCUs and the Emulator
[Flash memory synchronization]
combo box
[Step Over option] combo box
Selects whether or not the contents of the flash memory are
acquired by the emulator when the user program is stopped or
the position where the PC break is set is put back as the original
code.
When the flash memory is not programmed by the user program,
its contents need not be acquired by the emulator.
If there is no problem with the state that the program in the
flash memory has been replaced as the PC break code, the
position where the PC break is set needs not be put back as
the original code.
Disable: Read or program is not performed for the flash
memory except when the emulator is activated, the flash
memory area is modified, and the settings of the PC break to
the flash memory area are changed.
PC to flash memory: When the user program is stopped, the
specified PC break code is replaced as the original instruction.
Select this option if there is a problem with the state that the
program in the flash memory has been replaced as the PC
break code.
Flash memory to PC: When the user program is stopped, the
contents of the flash memory are read by the emulator. Select
this option if the flash memory is reprogrammed by the user
program.
PC to flash memory, Flash memory to PC:
When the user program is stopped, the contents of the flash
memory are read by the emulator and the specified PC break
code is replaced as the original instruction. Select this option if
the flash memory is reprogrammed by the user program and
there is a problem with the state that the program in the flash
memory has been replaced as the PC break code.
Enables or disables programming of the flash memory while
executing step operation.
Programming of the flash memory: Uses a software break for
step operation (e.g. Step Over) and enables programming of
the flash memory.
No Programming of the flash memory: Uses Break Condition for
step operation (e.g. Step Over) and disables programming of
the flash memory^*2.
Rev. 1.00 Aug.03, 2009 Page 21 of 22
REJ10J2022-0100