R0E00008AKCE00EP62 Datasheet, PDF (76/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCUs and the Emulator
Items that can be displayed in this dialog box are listed below.
[Device] combo box
Displays the MCU name.
[Emulation mode] combo box
Selects the emulation mode at user program execution.
Select Normal to perform normal emulation.
Select No break to disable PC breakpoint or break condition
settings during emulation.
[Step option] combo box
Sets the step interrupt option.
Disable interrupts during single step execution: Disables
interrupts^*1 during step execution.
Enable interrupts during single step execution: Enables
interrupts^*1 during step execution.
[NMI signal] group box
[User interface clock] combo box
Sets the use of the NMI# signal.
When used as a forced break in the emulator, select Emulator.
In this case, the NMI# signal cannot be used. The contents of
the NMI# vector address are rewritten by the emulator program.
When used in the user program, select User. In this case, the
forced break cannot be used. Before user program execution,
set the breakpoints or break conditions for the exception
processing and generate exceptions to halt the program.
Displays the transfer clock of the user interface.
[Breakcondition mode]
group box
Sets the address break release function.
When the address break function is not used in the user
program, select Emulator. In this case, the hardware break and
step functions can be used. The contents of the vector address
are rewritten by the emulator program to satisfy the break
conditions.
When the address break is used in the user program, select
User. In this case, the hardware break and step functions cannot
be used.
Rev. 1.00 Aug.03, 2009 Page 20 of 22
REJ10J2022-0100