R0E00008AKCE00EP62 Datasheet, PDF (48/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCUs and the Emulator
To keep the [Emulator Setting] dialog box closed next time the emulator is started, check "Do
not show this dialog box again." at the bottom of the [Emulator Setting] dialog box. You can
open the [Emulator Setting] dialog box using either one of the following methods:
⎯ After the emulator gets started, select Menu - [Setup] -> [Emulator] -> [Emulator
Setting...].
⎯ Start the emulator while holding down the Ctrl key.
⎯ After the emulator gets started and an error occurred, restart the emulator.
When you check "Do not show this dialog box again.", the emulator doesn't supply power to
the user system. To use this check box, start the emulator after turning on the power.
2. Emulator Mode
The selection of the device, the specification of the mode, and the setting of the power supply
are done in the [Emulator mode] page of the [Emulator Setting] dialog box.
⎯ Device
Select the device name in use from the [Device] combo box. The following items are
selected in the [Mode] group box.
⎯ Modes
• Erase Flash and Connect
This mode is used when there is no emulator program in the flash memory of the target
device. In this mode, data of the flash memory of the target device is erased when the
emulator is activated. Select this item when the emulator is firstly activated, the version
of the emulator’s software is updated, or the ID code is changed.
• Keep Flash and Connect
This mode is used when there is an emulator program in the flash memory of the target
device. Enter the ID code specified above (‘Erase Flash and Connect’). If an incorrect
code is entered, all the programs on the flash memory will be erased.
Note: When the emulator gets started in this mode after selecting "Do not show this dialog box
again.", the initial value of the ID code is ‘0E8a’. If you use the ID code other than the
initial value, do not use "Do not show this dialog box again.".
• Program Flash
This mode is used when the emulator is used for programming the flash memory.
Debugging the program is disabled. To download the load module, register it in the
workspace.
Note: In the H8/Tiny or H8/Super Low Power device, the ID code is not entered in the Program
Flash mode.
Rev. 1.00 Aug.03, 2009 Page 16 of 24
REJ10J2022-0100