R0E00008AKCE00EP62 Datasheet, PDF (23/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCUs and the Emulator
⎯ Power Supply
When [Power Target from emulator. (MAX 300mA)] is checked, power will be supplied to
the user system up to 300 mA. Then select 3.3 V or 5.0 V according to the power voltage
of the user system.
3. Emulator Activation and ID Code
In the H8/Tiny- or H8/Super Low Power-series MCU, the [System Clock] and [ID Code]
dialog boxes are set when the emulator is activated.
⎯ Setting the system clock
Enter the clock value input to the board in use. The initial value differs in each MCU.
Figure 5.2 [System Clock] Dialog Box
⎯ Setting the ID code
When the emulator is activated in the [Erase Flash and Connect] mode, enter any
hexadecimal four-digit ID code to be set (except for H'FFFF). The initial value is H'0E8A.
When the emulator is activated in the [Keep Flash and Connect] mode, enter the correct ID
code. If an incorrect ID code is entered, all the contents of the flash memory will be erased.
In this case, restart the emulator in the [Erase Flash and Connect] mode.
Figure 5.3 [ID Code] Dialog Box
Rev. 1.00 Aug.03, 2009 Page 17 of 26
REJ10J2022-0100