R0E00008AKCE00EP62 Datasheet, PDF (55/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

[Step Over option] combo box
[Flash memory write after
download] group box
Section 5 Differences between the MCUs and the Emulator
If there is no problem with the state that the program in the flash
memory has been replaced as the PC break code, the position where
the PC break is set needs not be put back as the original code.
Disable: Read or program is not performed for the flash memory
except when the emulator is activated, the flash memory area is
modified, and the settings of the PC break to the flash memory area
are changed.
PC to flash memory: When the user program is stopped, the
specified PC break code is replaced as the original instruction.
Select this option if there is a problem with the state that the
program in the flash memory has been replaced as the PC break
code.
Flash memory to PC: When the user program is stopped, the
contents of the flash memory are read by the emulator. Select this
option if the flash memory is reprogrammed by the user program.
PC to flash memory, Flash memory to PC:
When the user program is stopped, the contents of the flash memory
are read by the emulator and the specified PC break code is replaced
as the original instruction. Select this option if the flash memory is
reprogrammed by the user program and there is a problem with the
state that the program in the flash memory has been replaced as the
PC break code.
Enables or disables programming of the flash memory while
executing step operation.
Programming of the flash memory: Uses a software break for step
operation (e.g. Step Over) and enables programming of the flash
memory.
No Programming of the flash memory: Uses Break Condition for
step operation (e.g. Step Over) and disables programming of the
flash memory^*2.
Enables or disables programming of the flash memory after
downloading the program.
Disable: Disables programming of the flash memory after
downloading the program.
Enable: Enables programming of the flash memory after
downloading the program.
Notes: 1. Includes interrupts in a break.
2. When Step Over is performed after selecting [No Programming of the flash memory]
for [Step Over option], the instruction that follows a JSR, BSR, or TRAPA instruction
will also be executed. If there are consecutive JSR, BSR, or TRAPA instructions,
Rev. 1.00 Aug.03, 2009 Page 23 of 24
REJ10J2022-0100