R0E00008AKCE00EP62 Datasheet, PDF (31/82 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 5 Differences between the MCUs and the Emulator
Notes: 1. Includes interrupts in a break.
2. When Step Over is performed after selecting [No Programming of the flash memory]
for [Step Over option], the instruction that follows a JSR, BSR, or TRAPA instruction
will also be executed. If there are consecutive JSR, BSR, or TRAPA instructions,
execution proceeds until it reaches an instruction that is not JSR, BSR, or TRAPA.
(When there are consecutive function calls in C language, the program steps all of
these functions.)
23. Available MCUs for the Emulator
The H8/3684F, H8/36054F, H8/36034F, H8/3664N, H8/3687N, and H8/3694N are also
available for the emulator. When the emulator is activated, set the MCU to be selected as
shown in table 5.4. Note that, however, an error will not be displayed even if a program which
is larger than the internal ROM capacity is downloaded.
Table 5.4 List of Available MCUs
MCU to be Used
H8/3684F, H8/3687N
H8/3664N
H8/3694N
H8/36054F
H8/36034F
MCU to be Selected
H8/3687F
H8/3664F
H8/3694F
H8/36057F
H8/36037F
24. Restriction on Software Write Enable (SWE) Bit
If the SWE bit is set to 1 during execution of the user program, a communication timeout error
will occur. Do not set this bit to 1.
Rev. 1.00 Aug.03, 2009 Page 25 of 26
REJ10J2022-0100